Check the AIT conveyor goes up and down evenly

WHAT YOU NEED 

Tools:Allen Key Set

Safety Equipment:Standard Personal Protective Equipment

CAUTIONWhen using material handling in the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

1. Inspect the AIT for signs of damage or wear, and for any rubbish or bits of timber that may prevent correct movement.

2. In the Material Handling window, click  to lower the conveyor and perform the following checks:

   • Make sure no cables are being pinched or any part of the conveyor is rubbing.

   • Visually check that the conveyor moves into position correctly and in an even motion.

     Note: the full movement should not be jerking and the conveyor should stay perfectly level while travelling.

3. Click  to raise the conveyor and perform the same checks.
4. If the up and down motion is not even, adjust the AIT air cylinder cushioning and restrictors as required.